reload the wireless device image using the CLI on AP 1200

bpeacock2598 — Sat, 03 Jul 2021 20:48:54 GMT

I am trying to reload an image on my AP 1231G-A-K9, and it is not allowing me to go to the ap: prompt when pressing ESC and the flash load#############. Thanks in advance

Re: reload the wireless device image using the CLI on AP 1200

csannedhi — Mon, 26 Mar 2007 23:28:08 GMT

You may need to follow the procedure explained below:

Step 1 Set the static IP address of the PC on which your TFTP server software runs to an address between 10.0.0.2 and 10.0.0.30.

Step 2 Make sure that the PC contains the access point image file (such as c1100-k9w7-tar.123-8.JA.tar for a 1100 series access point) in the TFTP server folder and that the TFTP server is activated.

Step 3 Rename the access point image file in the TFTP server folder to c1100-k9w7-tar.default.

Step 4 Connect the PC to the access point using a Category 5 (CAT5) Ethernet cable.

Step 5 Disconnect power from the access point.

Step 6 Press and hold the MODE button while you reconnect power to the access point.

Step 7 Hold the MODE button until the Radio LED turns red (approximately 20 to 30 seconds) and then release.

Step 8 Wait until the access point reboots, as indicated by all LEDs turning green followed by the Status LED blinking green.

Step 9 After the access point reboots, reconfigure it using the access point GUI or the CLI.

HTH

topic reload the wireless device image using the CLI on AP 1200 in Wireless

reload the wireless device image using the CLI on AP 1200

Re: reload the wireless device image using the CLI on AP 1200