topic Re: 1130: Error!!! Command is disabled in Wireless

1130: Error!!! Command is disabled

heinz.kern — Sun, 04 Jul 2021 01:03:00 GMT

hi,

i have the following problem: i have set a lwapp-ap to factory default via the GUI but used the feature "except static IP". now the access-point is up but can not join a controller because it doesn't have a controller IP. the controller is not in the same subnet and i don't have physical access to the access-point (only access via SSH).

when i try to issue "lwapp ap controller ip" then i receive: Error!!! Command is disabled. (username/passworf is not set). i can login with default Cisco/Cisco.

do i have a possibility to solve this issue from remote?? (a dhcp-server would be available with option 43)

Re: 1130: Error!!! Command is disabled

Leo Laohoo — Tue, 15 Sep 2009 21:56:10 GMT

You have two options.

One, convert to Autonomous and re-convert back to LWAPP.

Two, the command is "disabled" because you are already running the LWAPP image. Your LWAP contains two IOS images: One has the prefix of "rcv" and the other is the image downloaded from the WLC. Delete this image, let the AP boot the "rcv" image and run the command again.

Re: 1130: Error!!! Command is disabled

heinz.kern — Wed, 16 Sep 2009 03:23:24 GMT

hi,

thanks for your response. the problem is: how can i reboot the access-point from remote? currently i can't see a command in the CLI where i can reboot it....

Re: 1130: Error!!! Command is disabled

Leo Laohoo — Wed, 16 Sep 2009 04:51:31 GMT

In that case, you need to take back the AP because the procedure that I've posted has to be done using the console cable.

Re: 1130: Error!!! Command is disabled

heinz.kern — Wed, 16 Sep 2009 05:11:06 GMT

thanks for your help