topic Error Command is disabled - from lwapp CLI in Wireless https://community.cisco.com/t5/wireless/error-command-is-disabled-from-lwapp-cli/m-p/821895#M68394 <P>Hello,</P><P></P><P>i keep getting this message when trying to restore back to default or clear controller ip definations in the lwapp ap. How do i get around this?</P> Sat, 03 Jul 2021 21:45:37 GMT admin_2 2021-07-03T21:45:37Z Error Command is disabled - from lwapp CLI https://community.cisco.com/t5/wireless/error-command-is-disabled-from-lwapp-cli/m-p/821895#M68394 <P>Hello,</P><P></P><P>i keep getting this message when trying to restore back to default or clear controller ip definations in the lwapp ap. How do i get around this?</P> Sat, 03 Jul 2021 21:45:37 GMT https://community.cisco.com/t5/wireless/error-command-is-disabled-from-lwapp-cli/m-p/821895#M68394 admin_2 2021-07-03T21:45:37Z Re: Error Command is disabled - from lwapp CLI https://community.cisco.com/t5/wireless/error-command-is-disabled-from-lwapp-cli/m-p/821896#M68395 <HTML><HEAD></HEAD><BODY><P>Hi Friend,</P><P></P><P>East way is let it join controller first and then you can reset the configuration of AP from controller GUI.</P><P></P><P>If that is not possible for you for any reason you can console into AP and issue a command "dir flash" and you will see 2 files name "env_vars" and "private" name file. Delete it from flash running a command "delete flash:env_vars" and same command to delete second file and just reload the AP and it will delete old configuration regarding controller ip address.</P><P></P><P>HTH</P><P></P><P>Ankur</P><P></P><P>*Pls rate all helpfull post</P></BODY></HTML> Fri, 12 Oct 2007 16:33:15 GMT https://community.cisco.com/t5/wireless/error-command-is-disabled-from-lwapp-cli/m-p/821896#M68395 ankbhasi 2007-10-12T16:33:15Z