topic Turn WLC Debug on Permanently in Wireless

Turn WLC Debug on Permanently

malcolmtkelly — Sun, 04 Jul 2021 07:57:40 GMT

Hi, I currently have my WLC syslogging debug messages to a Syslog Server. It works fine except the messages I'm getting are rather mundane. In order to get what I really want to log I have to turn on a particular debug through the terminal. Like:

debug capwap events enable

For example.

When I do this all the information you would see on the terminal is sent to the syslog server and all is good. However, as soon as I disconnect the terminal (console or VTY) the debug command is removed and the level of logging falls back.

Does anyone know how I might turn on the above command permanently so that even if there's not a session on the device it's still sending back the relevant log information to the syslog server?

Thanks

Re: Turn WLC Debug on Permanently

Viten Patel — Sat, 28 Sep 2013 07:17:32 GMT

Not possible

Sent from Cisco Technical Support iPhone App

Re: Turn WLC Debug on Permanently

Abha Jha — Tue, 01 Oct 2013 22:00:45 GMT

debug will be turned ON until and unless it is disabled by no debug command.

Also once the session is closed the debug will be gone and again you will have to turn on the debug

Re: Turn WLC Debug on Permanently

kaaftab — Wed, 02 Oct 2013 01:02:59 GMT

Kindly check the following links for references

http://www.cisco.com/en/US/products/ps6307/products_configuration_example09186a00809a2d76.shtml