topic Re: Aironet 1200 Telnet Issue in Wireless

Aironet 1200 Telnet Issue

jfrye5445 — Sun, 04 Jul 2021 18:48:48 GMT

I have a Aironet that was on a 2651 router with DCHP enabled. We have swapped providers and to a router with no DCHP. Now i cannot assign the aironet an Ip address or change the gateway. I am trying to telnet in but am only getting to an (ap> Prompt). i am doing this by tryuing to access thru the console

I see no way to config it. I am able to connect to the wireless but I have to manually assign an IP on my PC. My customers will need to be able get to it without this issue.

Any help would be appreciated

Re: Aironet 1200 Telnet Issue

alinn — Mon, 20 Mar 2006 21:46:37 GMT

Hello.

Ok if you at the 'ap>' prompt you will need to get into enable mode before configuration the ip address on the bvi interface.

So the cli commands would be:

ap>

ap>enable

password:

Enter your password. Default username and password are 'Cisco'

ap# config t

ap(config)# interface bvi1

ap(Config-if)# Ip address

ap(Config-if)#end

ap#

Hope this helps.

Regards,

Aaron

Re: Aironet 1200 Telnet Issue

jfrye5445 — Tue, 21 Mar 2006 13:27:31 GMT

thanks for the reply aalinn

That solved the issue and i am able to access the web interface now.

Thanks again!