topic Re: where to change name and location of an AP on the CLI in Wireless

where to change name and location of an AP on the CLI

mojogar — Mon, 05 Jul 2021 15:21:58 GMT

I want to change the name and location of AP's that are connected to my 3650 wireless control module. I have found a post that list these commands as:

config ap name

Then you can also add the location value of the ap:

config ap location

However, I have not found where to enter these commands on the switch (do i need to VTY into the AP?).

Switch is a 3650

AP is a 3802

Re: where to change name and location of an AP on the CLI

Ric Beeching — Sat, 10 Mar 2018 07:29:28 GMT

Hi,

Can you do a show wireless ap summary on your switch? You just need to be in in enable mode to change them name, not global config.

Cheers,

Ric

Re: where to change name and location of an AP on the CLI

mojogar — Mon, 12 Mar 2018 16:52:29 GMT

the commands i needed to do in enable mode were:

ap <name> [perameter] (in this case its location)

Example:

ap ap1234.abcd.4321 location RMxxx