topic CLI commande for SSID mapping to tunnel in Wireless

CLI commande for SSID mapping to tunnel

nt0000001 — Mon, 05 Jul 2021 13:37:13 GMT

Hello,

What would be the commande to map an SSID ti a mobility tunnel ?

In WEB mode (in attachement) we have :

WLAN > WLAN index (conf) Mobility Anchors and here i have "Mobility Anchor Create" and i put the IP of other WLC.

On the Anchor WLC a create an mobility anchor "Local".

How can i do this in CLI ?

Thx

Hi

Rasika Nayanajith — Tue, 28 Feb 2017 17:35:52 GMT

As long as you configure mobility peering between those two WLC, you can configure a WLAN via CLI to anchor as shown below

(WLC) >config wlan mobility ? 
anchor Configures the Mobility WLAN anchor list. 
foreign-map Configures the Mobility WLAN foreign-map.
 
(WLC) >config wlan mobility anchor ? 
add Add/Change a Mobility anchor to a WLAN.
delete Delete a Mobility anchor from a WLAN.
 
(WLC) >config wlan mobility anchor add ? 
<WLAN Id> WLAN identifier between 1 and 512.
 
(WLC) >config wlan mobility anchor add 100 ? 
<IP addr> Member switch IP address to anchor WLAN

Here is reference to mobility peering config

https://mrncciew.com/2013/05/20/mobility-config-via-cli/

HTH

Rasika

*** Pls rate all useful responses ***

Thanks,

nt0000001 — Sat, 04 Mar 2017 19:55:36 GMT

Thanks,

But what about "local" mapping ?

as i said the WLC1 will "tunnel" de traffic to WLC2. WLC2 will "keep" traffic as local (Create mobility anchor > local)

Should i put his own IP in CLI ?

But what about "local"

Rasika Nayanajith — Sun, 05 Mar 2017 22:31:17 GMT

But what about "local" mapping ? Should i put his own IP in CLI ?

Yes, you use same command syntax. You will use same controller mgmt IP address if that is anchor WLC.

HTH

Rasika

OK Thank you so much.

nt0000001 — Wed, 15 Mar 2017 22:34:29 GMT

OK Thank you so much.

This subject is closed for me

PS: i'm very often on your web to find some responses