topic Re: How to configure rogue detector to scan all vlans ? in Wireless https://community.cisco.com/t5/wireless/how-to-configure-rogue-detector-to-scan-all-vlans/m-p/1308508#M77512 <HTML><HEAD></HEAD><BODY><P>the native vlan has to be the same that your management interface is in. You will then need to make sure that the controller is able to see the wired networks that the "on-wire" rogues could potentially be connected to.</P><P></P><P></P></BODY></HTML> Thu, 09 Jul 2009 01:02:50 GMT ericgarnel 2009-07-09T01:02:50Z How to configure rogue detector to scan all vlans ? https://community.cisco.com/t5/wireless/how-to-configure-rogue-detector-to-scan-all-vlans/m-p/1308507#M77511 <P>I read the guide and found that, the rogue detector need to use trunk link connect to switch, does it means we need to change the native vlan respectively (vlan 1 won't be use in normal situation) and is there any special configuration need to do at rogue detector?</P> Sun, 04 Jul 2021 00:48:23 GMT https://community.cisco.com/t5/wireless/how-to-configure-rogue-detector-to-scan-all-vlans/m-p/1308507#M77511 jason_majie 2021-07-04T00:48:23Z Re: How to configure rogue detector to scan all vlans ? https://community.cisco.com/t5/wireless/how-to-configure-rogue-detector-to-scan-all-vlans/m-p/1308508#M77512 <HTML><HEAD></HEAD><BODY><P>the native vlan has to be the same that your management interface is in. You will then need to make sure that the controller is able to see the wired networks that the "on-wire" rogues could potentially be connected to.</P><P></P><P></P></BODY></HTML> Thu, 09 Jul 2009 01:02:50 GMT https://community.cisco.com/t5/wireless/how-to-configure-rogue-detector-to-scan-all-vlans/m-p/1308508#M77512 ericgarnel 2009-07-09T01:02:50Z