topic Virtual Wireless Controller Licenses in Wireless

Virtual Wireless Controller Licenses

khan300 — Mon, 05 Jul 2021 10:20:54 GMT

Dear Team,

I need to download the below licenses for a virtual controller but after i put the PAK number, it asks for a Product ID and serial number ? Which serial number should i put over there as it is not a physical controller?

L-AIR-CTVM-5-K9

L-LIC-CTVM-UPG

Thanks

To determine the controller’s

Saurav Lodh — Fri, 05 Jun 2015 00:56:00 GMT

To determine the controller’s product ID and serial number, choose Controller > Inventory on the controller GUI or enter the show license udi command on the controller CLI.

Information similar to the following appears on the controller CLI:
Device# PID SN UDI
------- -------------------- ----------------------- ---------------------------------
*0 AIR-CT5508-K9 FCW1308L030 AIR-CT5508-K9:FCW1308L030

Yup thats correct but thats

khan300 — Fri, 05 Jun 2015 20:53:43 GMT

Yup thats correct but thats for when I''m adding licenses to an already installed virtual controller. What about when I want to download the license for the virtual controller(L-AIR-CTVM-5-K9) its self. what prodcut ID and serial number should i write? I cant go into the controller since i havent installed the controller yet 🙂

Refer the link : https:/

mohanak — Tue, 09 Jun 2015 09:18:13 GMT

Refer the link : https://supportforums.cisco.com/discussion/11780436/vwlc-first-time-download

https://supportforums.cisco.com/discussion/11873136/adding-license-key-virtual-wireless-lan-controller

You have to install the vWLC

Freerk Terpstra — Tue, 09 Jun 2015 21:20:48 GMT

You have to install the vWLC first, which comes with an 60 day trial license. After you did that you can use the normal procedure.

If you don't have access to the .ova file to deploy the vWLC because you don't have a valid service contract (because you don't have an serial number yet..), you need to contact TAC so that they can provide an one-time-download for you.

Please rate useful posts 🙂