topic Re: Issues with new controller in Wireless https://community.cisco.com/t5/wireless/issues-with-new-controller/m-p/722548#M80727 <HTML><HEAD></HEAD><BODY><P>This is definitely a configuration issue. Can you post the configuration so that we can see where the problem is?</P><P></P></BODY></HTML> Mon, 09 Jul 2007 17:15:22 GMT bbaley 2007-07-09T17:15:22Z Issues with new controller https://community.cisco.com/t5/wireless/issues-with-new-controller/m-p/722547#M80726 <P>SO I have setup a few controllers in the past with multiple SSID and Interfaces. I am trying the same again and I cannot get it to work. I have a 2600 router plugged into a 2950-24 and my 4 networks are routing fine and all is working. I have a 3560-48ps with my phones and now my controller plugged into gi0/2. I have set the port up as a trunk and allowed my vlans on it. If I have one interface on the controller for my management vlan x.x.10.x all works fine from my pc on the x.x.100.x network. I then add my other vlans via dynamic interfaces on the controller x.x.100.x, x.x.101.x, x.x.102.x, x.x.103.x, and I cannot no longer access the controller form the x.x.100.x network. I can access it from the x.x.10.x network however. I have checked all settings and all looks good but cannot figure why traffic does not appear to be routing to the controller. From my pc I can run a tracert and get to my switches, but when I try to get to the controller it fails at the second hop. Any ideas?</P> Sat, 03 Jul 2021 21:17:27 GMT https://community.cisco.com/t5/wireless/issues-with-new-controller/m-p/722547#M80726 nshoe18 2021-07-03T21:17:27Z Re: Issues with new controller https://community.cisco.com/t5/wireless/issues-with-new-controller/m-p/722548#M80727 <HTML><HEAD></HEAD><BODY><P>This is definitely a configuration issue. Can you post the configuration so that we can see where the problem is?</P><P></P></BODY></HTML> Mon, 09 Jul 2007 17:15:22 GMT https://community.cisco.com/t5/wireless/issues-with-new-controller/m-p/722548#M80727 bbaley 2007-07-09T17:15:22Z