topic HI GoodBoy, in Wireless

WIRELESS

badboy_84 — Mon, 05 Jul 2021 11:26:02 GMT

Can I configure Cisco 1602i (AIR-CAP1602I-T-K9) in Standalone mode, I have to configure that access- point but I can´t, I tried to get into configure terminal, but it does not regonize the cli mode, I´m lost is there anyone to help me !!

HI GoodBoy,

Sandeep Choudhary — Wed, 23 Dec 2015 19:40:01 GMT

HI GoodBoy,

Yes you can configure as standalone AP.

I think this AP has controller based image. So you need to enable it first to start config by using this command: debug capwap console cli

1. You must need to convert this AP from CAP to standalone mode.

How: - download this image: https://software.cisco.com/download/release.html?mdfid=284366503&softwareid=284180979&release=15.3.3-JC&relind=AVAILABLE&rellifecycle=ED&reltype=latest

- use this method: https://rscciew.wordpress.com/2014/05/07/access-point-conversion-lap-to-aap-and-vice-versa/

- https://www.youtube.com/watch?v=QQ_NuxdRhQ4

2. After conversion you can start configuration .....

https://rscciew.wordpress.com/2014/05/24/single-ssid-configuration-on-autonomous-ap/

Regards

Dont forget to rate helpful posts

Refer the link : https:/

mohanak — Thu, 24 Dec 2015 09:11:32 GMT

Refer the link : https://supportforums.cisco.com/discussion/12266931/can-i-configure-cisco-1602i-air-cap1602i-t-k9-standalone-mode

https://supportforums.cisco.com/discussion/12079081/how-configure-aironet-1602i-standalone-wap