topic Check the link below ,example in Wireless

Wireless LAN Connection Configuration

ja.patrick1080 — Mon, 05 Jul 2021 09:57:05 GMT

Need Basic Wireless LAN Connection Configuration Example

any update

ja.patrick1080 — Thu, 16 Apr 2015 19:22:42 GMT

any update

HiThis link provide WLC

Rasika Nayanajith — Mon, 20 Apr 2015 00:08:36 GMT

This link provide WLC configuration examples

http://www.cisco.com/c/en/us/support/wireless/5500-series-wireless-controllers/products-configuration-examples-list.html

Refer config guides if you need step by step guide for all features configurations

HTH

Rasika

*** Pls rate all useful responses ***

http://www.cisco.com/c/en/us

Moin Ilyas — Mon, 20 Apr 2015 09:13:26 GMT

http://www.cisco.com/c/en/us/tech/wireless-2f-mobility/wireless-lan-wlan/tech-configuration-examples-list.html

Hope that helps.

Check the link below ,example

gohussai — Tue, 21 Apr 2015 02:01:37 GMT

Check the link below ,example with Cisco best practice.

http://www.cisco.com/c/en/us/td/docs/wireless/technology/wlc/82463-wlc-config-best-practice.html

Hey James, Please go through

Prakash Parvathala — Thu, 30 Apr 2015 20:56:34 GMT

Hey James,

Please go through the below links which can help you on best practices for basic WLC configurations.

http://www.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-lan-wlan/68005-wlan-connect.html

http://www.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-lan-wlan/116584-configure-wirelesslan-00.html

Hi Everyone,

shah.a.jawad — Mon, 14 Mar 2016 07:47:52 GMT

Hi Everyone,

I have a scenario in which WLC 2504 is connected to Core switch 4507R+E.and access switches are connected to Core switch as well. In these access switches Access points AIR-CAP702I-A-K9.

My question is as follows:

I want to use vlan 104 for office employes with SSID OFFICE-EMPLOYES

I want to use vlan 103 for guest with SSID Office-Guests

Below is what i have configured on core switch

(config)#interface xx

(config)#description xxx

(config)#switchport mode trunk

(config)#switchport trunk allowed vlan 103,104

Below is what i have configured on access switches

(config)#interface xx

(config)#swithcport mode access

(config)#swithcport access vlan 104

If i am configuring trunk port on access switches and allowing both vlan's 103 & 104 access points are not joining controller.

Right now management IP is from vlan 104 and all access points and clients are getting ip from 104 vlan.

What shall i do in this scenario.I want to use segregate the guest and office employe traffic.

It would be great if any one can help me.