topic Re: HELP WIRELESS MESH in Wireless

HELP WIRELESS MESH

pgonzalez — Sun, 04 Jul 2021 01:15:53 GMT

Hi Guys

I need someone can help me please, my problem is this:

We have a wireless mesh network with 2 WLC and 24 LAP1510AG (4 RAPs), which are registered to the WLC 1 when tested HA, i turn off the WLC 1 to operate the WLC 2, there were only 12 of the 24 APs are registred with WLC 2, when we made the turn of the WLC 1 have been recorded the same 12.

the debug LWAPP events enable command only shows activity of registered APs.

We have set to factory defaults all APs register (12) but nothing.

Any help be welcome

Thank you very much

Re: HELP WIRELESS MESH

ehlers.kevin — Mon, 16 Nov 2009 17:55:26 GMT

Did you add the mesh mac addresses to the mac filtering database? That's usually the problem when mesh aps don't join our controllers.

Re: HELP WIRELESS MESH

pgonzalez — Mon, 16 Nov 2009 18:15:41 GMT

if I added all the APs to the MAC-Filtering

Re: HELP WIRELESS MESH

pgonzalez — Mon, 16 Nov 2009 18:29:35 GMT

The APs have been properly recorded with the WLC1, the problem arises when shut down WLC1 then the APs not registered with WLC2 only do 12.

Re: HELP WIRELESS MESH

ehlers.kevin — Mon, 16 Nov 2009 18:33:38 GMT

Have you done

debug pm pki enable

on the controllers? You should see those messages even if you don't see the capwap messages.