topic Re: Wireless link using 1242AG dot11 1 (802.11a ) interface in Wireless

Wireless link using 1242AG dot11 1 (802.11a ) interface

akaliptos — Sat, 03 Jul 2021 21:23:43 GMT

Well, I face a slightly annoying problem here.

I am trying to establish a 5GHz connection between two 1240 AP connected to 5195 patch antennas (9.5dBi)

One is configured as root bridge while the other is a non-root bridge.

Although, in the same way I have configured many 802.11g links, this time the 802.11a link refuses to work.

Has anyone faced a similar problem on 1242 access points using the 5GHz interface?

I will shortly post this portion of the running config.

Any ideas appreciated.

Thanks

Re: Wireless link using 1242AG dot11 1 (802.11a ) interface

Tue, 31 Jul 2007 18:56:13 GMT

This setup should work. As long as you have two 5 Ghz radios you should not have any issues establishing a connection between them. Once you post the configuration we should be able to tell if there is any configuration error. Did you try any other 5 Ghz radio? because I suspect an issue with the hardware.

Re: Wireless link using 1242AG dot11 1 (802.11a ) interface

p.greuniesen — Thu, 02 Aug 2007 19:57:59 GMT

I faced this problem 2 times. Once when I didn't configure the same ssid on both APs, once when I slightly moved once of the 5Ghz antenna cables. Aparently on my setup I may have had a TNC connector/cable with a loose center pin or something, but once I reset/retighted the cable all was well.

Re: Wireless link using 1242AG dot11 1 (802.11a ) interface

advantexpix — Tue, 16 Oct 2007 09:28:59 GMT

I have just installed the same solution and had it working in our office about 30m but when we installed on site 150m-200m we cannot get a connection.