topic Re: log wireless in Wireless

log wireless

albertog — Sun, 04 Jul 2021 17:43:46 GMT

I have one printer zebra with a printserver wireless + card Cisco aironet 350 series.

When I have configured the printer and the card, the Ap give me the next log.( atthached).

¿ what is the motive ?

Thanks

Re: log wireless

thisisshanky — Thu, 05 May 2005 00:25:12 GMT

See if you can uncheck Aironet extensions on the 350 series and see if that helps!

http://www.cisco.com/en/US/products/hw/wireless/ps430/products_qanda_item09186a008009483e.shtml

Re: log wireless

karthiknarasimhan — Thu, 26 May 2005 15:36:26 GMT

Hey Albert,

Just happened to take a look @ the logs. Well the messages in there are not that descriptive.

The first event in the log may be due to interference or even if there was a delay in association with the AP. And is not much of a problem. You may get this message even at a timeout while association.

Whereas the second one clearly states that the authentication failed. Please let me know what's the security feature in use in this particular setup. And also some details on the AP & configurations would help determining why this message was logged.

Is there any issue that you face which corresponds to this exent log messages? Maybe I can help you with this.

Thanks & Regards,

Karthik Narasimhan

Re: log wireless

melisei — Fri, 03 Jun 2005 14:58:18 GMT

Hi there,

I didn't have the time to look at the log but I can tell you that the older Zebras use 350s and they use... SHARED authentication. Also, the printer will accept the WEP only in HEX.

I hope this helps,