topic Can a Flexconnect (h-reap) survive reload while in standalone mo in Wireless

Can a Flexconnect (h-reap) survive reload while in standalone mode

sin — Sun, 04 Jul 2021 05:10:05 GMT

I have searched and asked round for this the last weeks. Can't find the answer.

When a flexconnect is in standalone mode (WAN down) what happens if the AP is reloaded?

Is it possible to make a setup with i.e. WPA/PSK where the AP keeps working after a reload in standalone mode ?

Chears

Rasmus

Can a Flexconnect (h-reap) survive reload while in standalone mo

Leo Laohoo — Tue, 15 May 2012 10:25:59 GMT

When a flexconnect is in standalone mode (WAN down) what happens if the AP is reloaded?

When your WAN link(s) goes down and your FlexConnect (H-REAP) WAP reboots, it will not service anything/anyone.

Can a Flexconnect (h-reap) survive reload while in standalone mo

sin — Tue, 15 May 2012 10:30:06 GMT

Thanks. That was what I inspected but could not find any documentation for it.

Can a Flexconnect (h-reap) survive reload while in standalone mo

Saravanan Lakshmanan — Fri, 22 Jun 2012 21:40:13 GMT

After reboot it is expected that hreap/flexconnect AP to retain the config and serve local clients, if it is not doing so then it is broken. However, this behavior is not documented in cco.