topic Re: Problem with Client Disconnect in Wireless https://community.cisco.com/t5/wireless/problem-with-client-disconnect/m-p/1218376#M95005 <HTML><HEAD></HEAD><BODY><P>Hii </P><P></P><P>when you are facing this issue is ur HREAP AP is connected mode ?</P><P></P><P>What are the authentication type used for the client ?</P><P></P><P>1. Issue the command "debug client <MAC>" on the controller to further debug </MAC></P><P></P><P>2.Sniff the air with the client MAC address on the channel where client is connected using omnipeek.</P><P></P><P>Thanks </P><P>Vinay</P></BODY></HTML> Sun, 07 Jun 2009 06:51:10 GMT Vinay Saini 2009-06-07T06:51:10Z Problem with Client Disconnect https://community.cisco.com/t5/wireless/problem-with-client-disconnect/m-p/1218375#M95004 <P>I Have problem with Client Disconnect, we use WLC 4400 and LAP 1250 configured with HREP mode. Some clients are disconnect, how can I do Trobleshooting about that ?</P> Sun, 04 Jul 2021 00:41:05 GMT https://community.cisco.com/t5/wireless/problem-with-client-disconnect/m-p/1218375#M95004 jcardozo 2021-07-04T00:41:05Z Re: Problem with Client Disconnect https://community.cisco.com/t5/wireless/problem-with-client-disconnect/m-p/1218376#M95005 <HTML><HEAD></HEAD><BODY><P>Hii </P><P></P><P>when you are facing this issue is ur HREAP AP is connected mode ?</P><P></P><P>What are the authentication type used for the client ?</P><P></P><P>1. Issue the command "debug client <MAC>" on the controller to further debug </MAC></P><P></P><P>2.Sniff the air with the client MAC address on the channel where client is connected using omnipeek.</P><P></P><P>Thanks </P><P>Vinay</P></BODY></HTML> Sun, 07 Jun 2009 06:51:10 GMT https://community.cisco.com/t5/wireless/problem-with-client-disconnect/m-p/1218376#M95005 Vinay Saini 2009-06-07T06:51:10Z Re: Problem with Client Disconnect https://community.cisco.com/t5/wireless/problem-with-client-disconnect/m-p/1218377#M95006 <HTML><HEAD></HEAD><BODY><P>The client debug is a good place to start and here is a document explaining that process.</P><P></P><P><A class="jive-link-custom" href="http://www.cisco.com/en/US/products/hw/wireless/ps430/products_tech_note09186a008091b08b.shtml" target="_blank">http://www.cisco.com/en/US/products/hw/wireless/ps430/products_tech_note09186a008091b08b.shtml</A> </P><P></P><P>You many want to do dot11 debugs as well. But sniff the air first and see what activity you see... Also check your clients for a possible misconfig.</P></BODY></HTML> Sun, 07 Jun 2009 12:32:48 GMT https://community.cisco.com/t5/wireless/problem-with-client-disconnect/m-p/1218377#M95006 George Stefanick 2009-06-07T12:32:48Z