topic Re: Root/Non-Root disconnecting in Wireless

Root/Non-Root disconnecting

naive.naive — Sun, 04 Jul 2021 19:25:07 GMT

I've a pair of root/non-root bridge keep on disconnecting giveing the error message : parent loss..deauthenticating...and after few seconds, it reconnects back..

what may caused this?? is there a tool where i can measure inteference..

Re: Root/Non-Root disconnecting

a.kiprawih — Thu, 22 Jun 2006 02:51:52 GMT

Hi,

It normally due to bad signal, but could be other factors too like interference from other devices/signal or due to same channel used by other bridge-pair in surrounding area.

You can run the carrier signal test.

Rgds,

Re: Root/Non-Root disconnecting

naive.naive — Thu, 22 Jun 2006 03:58:36 GMT

done taht..and it says poor..

Re: Root/Non-Root disconnecting

fopravil — Sat, 01 Jul 2006 22:08:26 GMT

Hi,

I have got similar problem, I have found it is caused by the non-root bridge configured to use the wds device.

The "show dot11 ass" command issued on the root shows that the non-root bridge is in "AAA_ReAuth" state. When the non-root bridge gets authenticated, accepts the encryption key, starts exchanging data, and when connects to wds device, it switches its radio off, I do not know the reason. When the root bridge displays the message: "%DOT11-4-MAXRETRIES: Packet to client 0017.0f27.6f30 reached max retries, removing the client" the client stops disconneting.

Re: Root/Non-Root disconnecting

gray.adam — Sun, 02 Jul 2006 06:14:31 GMT

How many energy detect defers are you getting in 5 seconds?