debug flexconnect beacon announcements

Peter Boerjesson — Mon, 05 Jul 2021 14:23:56 GMT

I have a site with some 2802 and 1532 access points, based on information gathered form the site it's fairly obvious that beacons aren't annouced correctly for two out of the 3 SSID used at this location. On the 1532 there's one open guest network which is annouced correctly, there's one SSID with WPA2 PSK (AES and TKIP) which seems to be announced but with a null value of the SSID name and the last SSID running on dot11x doesn't even show up at all. I've logged on to the access points and tried a few debug commands as well as looking at the configuration, but can se anything that should be in error, the access points are connected to a 8540 WLC running 8.3.111.0 code running flexconnect. The 2802 and 1532 access points are configured with the same ap group and other settings. So, what can I debug or which show command could I possibly run in order to verify my suspicion incorrect announcements of the SSID from the1532 access points and what could I potentially do about it (restarting access points has already been tried). As this is a factory production environment I have to be a bit carful what I do as well.

Thanks for any help

Br //Peter

topic debug flexconnect beacon announcements in Wireless

debug flexconnect beacon announcements