topic it is enabled. that is how I in Wireless

Flexconnect: http & https

jacovr — Mon, 05 Jul 2021 08:11:24 GMT

Hi All.

I have 2 sites that are using Flexconnect AP's.

If I connect to the SSID, I am able to Ping & Telnet to my WLC & ISE Devices.

However. I'm unable to open a http or https connection to the devices.

I have no Access Lists blocking any traffic - I can open a https session up to the switch where the WLC & ISE device is connected to.

Any Ideas on this ?

Moin Ilyas — Thu, 10 Jul 2014 11:57:33 GMT

You would have to enable Wireless connections to the web browser.

Use the following command.

config network mgmt-via-wireless enable

Hope that works.

jacovr — Thu, 10 Jul 2014 14:45:18 GMT

it is enabled. that is how I access the WLC locally

Stephen Rodriguez — Thu, 10 Jul 2014 14:52:02 GMT

you may also need to:

config network mgmt-via-dynamic-interface enable

for it to work

HTH,

Steve

jacovr — Thu, 10 Jul 2014 14:54:11 GMT

Guys.

Please note I have this issue connecting to both my WLC & ISE Boxes

Stephen Rodriguez — Thu, 10 Jul 2014 14:56:54 GMT

oh well then....Check L3 for an ACL that blocks mgmt of the devices from certain subnets.

HTH,

Steve