topic connect only in Bn and not in Gn in Wireless

connect only in Bn and not in Gn

christophe schweitzer — Sun, 04 Jul 2021 06:40:14 GMT

Hello

I have a Controller 5508, CAP 3501E

I have a problem, all client who connect in 802.11n connect only in Bn and not in Gn.

When I diseable the n, the same client connect in 802.11g.

Could you help me that the client can connect in Gn

Thank you

christophe

connect only in Bn and not in Gn

Leo Laohoo — Tue, 05 Mar 2013 10:11:18 GMT

Go to Wireless > 802.11 b/g > Network.

Disable all data rates 12 Mbps and below. Make 18 as Supported and 24 as Mandatory.

connect only in Bn and not in Gn

christophe schweitzer — Tue, 05 Mar 2013 10:17:54 GMT

hello

thank for the answer

I test this protocole.

Thx

connect only in Bn and not in Gn

christophe schweitzer — Tue, 05 Mar 2013 10:50:45 GMT

Hello

I test this

Go to Wireless > 802.11 b/g > Network.

Disable all data rates 12 Mbps and below. Make 18 as Supported and 24 as Mandatory.

but not good result

the controller version is

Re: connect only in Bn and not in Gn

Scott Fella — Tue, 05 Mar 2013 12:06:14 GMT

So the requirements for 802.11n is:

Use open or WPA2/AES
Enable WMM
Optional is 40mgz channel width (5ghz only)

Sent from Cisco Technical Support iPhone App