topic Data Retries on Client details in Wireless

Data Retries on Client details

IT Services — Sun, 04 Jul 2021 07:48:29 GMT

Good Afternoon,

I was looking at a client detail on some of our Flex Connect AP's and in some instances I see a high number of Data Retries. Any indicitation as to what is causing this? Is it of any concern?

Data Retries on Client details

George Stefanick — Tue, 10 Sep 2013 20:05:01 GMT

Retries are normal in wifi. Lot of things can cause data retries like interference, multipath, crappy clients. Best to keep retries at or under 6% of TX frames.

When a station sends a data frame how it knows the destination received it, the receiving station sends an ACK. When it doesnt get an ACK back it sends it again.

Make sense?

__________________________________________________________________________________________
"Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin
__________________________________________________________________________________________
‎"I'm in a serious relationship with my Wi-Fi. You could say we have a connection."

Data Retries on Client details

Saurav Lodh — Wed, 11 Sep 2013 01:22:55 GMT

You can also configure the Data retries from radio setting , here it is :

Configuring the Maximum Data Retries

The maximum data retries setting determines the number of attempts the access point/bridge makes to send a packet before giving up and dropping the packet.

The default setting is 32. Beginning in privileged EXEC mode, follow these steps to configure the maximum data retries:


	Command	Purpose
Step 1	configure terminal	Enter global configuration mode.
Step 2	interface dot11radio 0	Enter interface configuration mode for the radio interface.
Step 3	packet retries value \| drop-packet	Set the maximum data retries. Enter a setting from 1 to 128. Use the drop-packet command to maintain association and drop the packets when the maximum retry value is reached.
Step 4	end	Return to privileged EXEC mode.
Step 5	copy running-config startup-config	(Optional) Save your entries in the configuration file.

Use the no form of the command to reset the setting to defaults.

Hope it helps Keep rating helpful threads