topic Re: SendDigits in Cloud Collaboration

SendDigits

Christopher Stock — Sun, 06 Dec 2015 17:17:27 GMT

Hello,

I was hoping someone might be able to help me out, I have a scenario where I need a button on a Cisco Phone where I can send DTMF tones after a call has been setup.

I have tired the following on both IP Communicator and a 8845 but no joy?

</CiscoIPPhoneExecute>

Send DTMF digits with service Button on 6941 du... | Cisco Communities

Source info

Cisco Unified IP Phone Services Application Development Notes Release 9.1(1) and Later - Internal URI Features [Support]…

Any suggestions would be greatly appreciated.

Re: SendDigits

nick.mueller — Mon, 07 Dec 2015 13:01:34 GMT

Have you tried it without the training :Cisco/Dialer? As I read it the application ID is not required, and if you in fact specify one then the digits will only be sent to that application ID (which I assume you do not have setup).

Re: SendDigits

Christopher Stock — Mon, 07 Dec 2015 22:37:45 GMT

That worked!

Thank you! I will buy you a beer if you are ever in the TO area or the next Cisco live!

Working code to send a DTMF Tone on an active call:

<?xml version='1.0' encoding='us-ascii'?>

</CiscoIPPhoneExecute>