topic Re: State of terminal/address while ringing in Call Control

State of terminal/address while ringing

ashish.nijai — Fri, 06 Jun 2014 16:09:36 GMT

Dear All,

I am facing an issue.

I want to check whether some device/address is in talking state or not.

I am using "if(((CallControlTerminalConnection)terminalConnection).getCallControlState() == CiscoTerminalConnection.TALKING )"

for my purpose.

But I am getting above condition as true when call is in ringing mode not in talking mode.

Please help me if i am wrong in any thing.

Regards,

Ashish Nijai

Re: State of terminal/address while ringing

mpotluri — Fri, 06 Jun 2014 16:54:45 GMT

Ashish,

You should use

if(((CallControlTerminalConnection)terminalConnection).getCallControlState() == CallControlTerminalConnection.TALKING)

since you are checking the call control state.

Let me know if this resolves the issue.

Re: State of terminal/address while ringing

ashish.nijai — Fri, 06 Jun 2014 18:43:54 GMT

Dear Mohan,

I am using if(((CallControlTerminalConnection)terminalConnection).getCallControlState() ==CallControlTerminalConnection.TALKING) also.

But I am getting same status.

I am getting CallControlTerminalConnection.TALKING state when terminal/address is ringing.

Re: State of terminal/address while ringing

mpotluri — Fri, 06 Jun 2014 18:55:10 GMT

Do you have call observers on both calling and called parties? Calling side terminal connection will go to TALKING state as soon as you start dialing. Can you check if the event is for called terminal?

Re: State of terminal/address while ringing

ashish.nijai — Fri, 06 Jun 2014 19:11:23 GMT

Dear Mohan,

Then how will we can check real talking event.

I need to put hold using calling terminal.

Re: State of terminal/address while ringing

upchaurasia — Wed, 11 Jun 2014 06:00:03 GMT

Ashish,

Both terminal connection should be in talking state.

Regards,

Umesh