topic Re: Issue found. Where to submit it in Controllers

Issue found. Where to submit it

bavo — Fri, 01 Mar 2019 12:29:19 GMT

Hi,

I found some thing that looks like an issue with the APIC-EM software pack.

Where can i summit this issue?

Re: Issue found. Where to submit it

Zach Seils — Wed, 13 Jul 2016 12:36:31 GMT

Hi Bavo,

Thanks for reaching out to the community. Can you describe the issue?

Zach

Re: Issue found. Where to submit it

bavo — Wed, 13 Jul 2016 13:02:32 GMT

Hi Seils,

I`m gonna try to explane.

Sins a short while we are using APIC-EM. Now we are using the “Path Trace” feature in APIC-EM. we found what seems to be an error.

When i use the "path trace" feature. I enter the source and destination host. When i hit "start trace"

The result is unfortunately not correct somehow. The result is al follow:

Host------Switch01----Router01----Switch02----Router01---Switch02----Router01-----Switch02----?

The error message is "unable to find path, showing partial path. Loop detected at device Router01"

Router01 is part of a Layer 2 EVPN. More locations can be seen with CDP commando.

But if i login on Router01 and i do a "sh ip route [destination ip]" is shows me the preferred path and egress interface.

The ergress interface is correct, but the next hop router is wrong.

This is how i should be i think:

Host-----Switch01----Router01----Router02----Router03----Switch03----Host

If i use other source and destination addresses the same problem keeps occurring.

Is there a way to debug the trace?

If you need more information pleas let me know.

I hop you can help me with this. Thanks in advanced

Greetings

Bavo

Re: Issue found. Where to submit it

Zach Seils — Wed, 13 Jul 2016 13:08:55 GMT

Can you run ‘rca’ from the APIC-EM Linux shell and upload the file that’s created? Please email me directly @ seils@cisco.com <mailto:seils@cisco.com> for the upload location.

Thanks,

Zach