topic Re: APIC-EM PnP Application upgrade issue in Controllers

APIC-EM PnP Application upgrade issue

javerill — Fri, 01 Mar 2019 12:39:54 GMT

I needed to reset my APIC-EM 1.5.0.1368 instance due a misconfiguration.

After running the "reset_grapevine" command from the CLI, the system restarts with PnP version 1.4.3.1009. I'm trying to upgrade this to version 1.5.0.211, but it doesn't appear to work properly.

Any ideas?

Thanks in advance,

Jason

Re: APIC-EM PnP Application upgrade issue

aradford — Tue, 01 Aug 2017 00:16:26 GMT

Hi Jason,

did you go into Admin-> App Management and check to see if you could disable old version and either enable or upload the new version?

Re: APIC-EM PnP Application upgrade issue

aradford — Tue, 01 Aug 2017 00:16:55 GMT

BTW, I assume you destroyed disks when you did a reset_grapevine?

Re: APIC-EM PnP Application upgrade issue

javerill — Tue, 01 Aug 2017 14:14:20 GMT

I have tried to disable / enable the app. that didn't make any difference.

I did destroyed the disks when I did the reset_grapevine.

This is a test instance, so I can do pretty much anything to the system short of reloading from the ISO. I can do that as well, but need to drag in another team to rebuild the VM.

Re: APIC-EM PnP Application upgrade issue

javerill — Tue, 01 Aug 2017 14:26:47 GMT

Just for good measure, I re-ran the reset_grapevine, making sure to destroy the disks.

I'll post the results once the system rebuilds.

Re: APIC-EM PnP Application upgrade issue

javerill — Tue, 01 Aug 2017 16:07:50 GMT

It appears that the 3rd time was the charm!

I was able to install the new version of the PnP application after the last reset_grapevine.

On to test IWAN!