topic Re: PKI not working after rebuilding HUB in Controllers

PKI not working after rebuilding HUB

ubsaccount — Fri, 01 Mar 2019 12:37:31 GMT

We had the hub sites deployed but wanted to change some stuff but you can't after you create them

So we rebuilt it now we can't get the PKI to work anymore.

Does anyone have a solution for this?

Re: PKI not working after rebuilding HUB

ngoldwat — Wed, 12 Apr 2017 23:34:45 GMT

You say you rebuilt them as opposed to redeploying them?

Re: PKI not working after rebuilding HUB

ubsaccount — Thu, 13 Apr 2017 00:06:58 GMT

Yes, we wiped out the configs rebuilt it and tried to redeploy them.

Re: PKI not working after rebuilding HUB

aradford — Thu, 13 Apr 2017 00:09:19 GMT

did you redeploy the spokes as well?

Re: PKI not working after rebuilding HUB

ubsaccount — Thu, 13 Apr 2017 00:25:06 GMT

We don't have any spokes yet

Re: PKI not working after rebuilding HUB

aradford — Thu, 13 Apr 2017 00:28:04 GMT

that is strange. Did you delete the hub from APIC before the reprovisioning?

Worst case, if you wanted to start again, you could just "reset_grapevine" and say "Y" to the destroy disk question. That would reset your controller completely and you could redeploy fresh. You should not need to do this?

Are you sure it is not a licensing issue? Do you have the correct licences on the HUB devices when you rebuilt them?