APIC-EM reloading router after deploying config

JPvisltgb — Fri, 01 Mar 2019 12:42:57 GMT

Hi!

I'm testing provisioning with C1111-8PLTEEA device and I found a strange behavior:

After config were deployed APIC-EM is reloading router.

Here is output from router console:

Mar 6 08:21:38.346 CET: %XML-SRVC: urn:cisco:pnp:config-upgrade XML Service(212) OK. PID=679

Mar 6 08:22:02.314 CET: %XML-UPDOWN: XEP_pnp-zero-touch_ XML Security(101) UNLOCKED. PID=679

Mar 6 08:22:11.166 CET: %XML-SRVC: urn:cisco:pnp:config-upgrade XML Service(212) OK. PID=679

***

*** --- SHUTDOWN NOW ---

***

Mar 6 08:22:16.211 CET: %SYS-5-RELOAD: Reload requested by controller. Reload Reason: Config upgrade.

In APIC-EM history info I see event "Running configuration upgrade to isr1100-test.txt was performed successfully"

Why I think that it is strange behavior, because I haven't seen this before with other devices: ISR4321, C1117-4PM and with some switches.

For example for C1117-4PM I see only two messages in APIC-EM :

Save startup Configuration was performed successfully

Device was successfully deployed!!

And router is not reloaded.

Uploaded config almost the same.

Does anybody knows why APIC-EM is reloading router ?

P.S After C1111-8PLTEEA is going up again from reload it is shutting down all interfaces except WAN. It just ignore "no shutdown" command in provisioned config.

Re: APIC-EM reloading router after deploying config

apicguy — Wed, 15 Aug 2018 19:13:58 GMT

Same issue for me (IR800 series).

APIC-EM Version 1.6.2.30018.
PnP - Version 1.6.2.102

topic Re: APIC-EM reloading router after deploying config in Controllers

APIC-EM reloading router after deploying config

Re: APIC-EM reloading router after deploying config