Device Errors Out While Pushing Config

shawn.dandridge — Fri, 01 Mar 2019 12:41:50 GMT

I always get an error on the status but apic em pushes the device. I get the following error message but the config is pushed to the device. Any ideas?

Received response from pnp agent for message correlatorId: CiscoPnP-1.0-17-494-3A341458-17 but with error code : ZTD_CMD_ERROR Response String: ERROR:PnP Service Error 1410:Invalid config found service log: % You already have RSA keys defined named RACTest41.rto.raccorp.corp. % They will be replaced. % The key modulus size is 2048 bits % Generating 2048 bit RSA keys, keys will be non-exportable... [OK] (elapsed time was 7 seconds) A pre-shared key for address mask 61.99.95.70 255.255.255.255 already exists! A pre-shared key for address mask 61.99.95.71 255.255.255.255 already exists! GigabitEthernet0/1 is already a backup for Serial0/0/0.333 % BGP: Incorrect network or mask/prefix-length configured % BGP: Incorrect network or mask/prefix-length configured

Re: Device Errors Out While Pushing Config

aradford — Sun, 03 Dec 2017 03:27:29 GMT

It looks like you have a certificate you are trying to push to the device?

APIC-EM has a built-in CA.

PnP will allocate and push a certificate to the device as part of the provisioning process.

It also looks like you have a config issue with your BGP.

GigabitEthernet0/1 is already a backup for Serial0/0/0.333 % BGP: Incorrect network or mask/prefix-length configured % BGP: Incorrect network or mask/prefix-length configured

topic Device Errors Out While Pushing Config in Controllers

Device Errors Out While Pushing Config

Re: Device Errors Out While Pushing Config