https://community.cisco.com/t5/network-platform-api/get-camera-boundaries-api-permissions/m-p/5415223#M2728 <P>Hi,</P><P> I was trying to use the new endpoint <SPAN>getOrganizationCameraBoundariesAreasByDevice to get the configured areas.</SPAN></P><P><SPAN>The issue arise when you have access to only some networks and not the whole organization. In this case the endpoint returns always 404 (Not Found) also </SPAN>specifying the camera serials (and not all the cameras).</P><P>On an Organization with full access it works as expected.</P><P>Any ideas?</P> Tue, 02 Apr 2024 13:11:41 GMT francesco.boscarino 2024-04-02T13:11:41Z https://community.cisco.com/t5/network-platform-api/get-camera-boundaries-api-permissions/m-p/5415223#M2728 <P>Hi,</P><P> I was trying to use the new endpoint <SPAN>getOrganizationCameraBoundariesAreasByDevice to get the configured areas.</SPAN></P><P><SPAN>The issue arise when you have access to only some networks and not the whole organization. In this case the endpoint returns always 404 (Not Found) also </SPAN>specifying the camera serials (and not all the cameras).</P><P>On an Organization with full access it works as expected.</P><P>Any ideas?</P> Tue, 02 Apr 2024 13:11:41 GMT https://community.cisco.com/t5/network-platform-api/get-camera-boundaries-api-permissions/m-p/5415223#M2728 francesco.boscarino 2024-04-02T13:11:41Z https://community.cisco.com/t5/network-platform-api/get-camera-boundaries-api-permissions/m-p/5415224#M2729 <P>I haven't used it but I assume because it returns data from the entire organization then you need org wide privilege.</P> Wed, 03 Apr 2024 07:27:53 GMT https://community.cisco.com/t5/network-platform-api/get-camera-boundaries-api-permissions/m-p/5415224#M2729 Adrian41 2024-04-03T07:27:53Z