2012年10月25日(初版)
TAC SR Collection |
---|
主な問題 | デスクトップシリーズスイッチで、interface range コマンドを使用して複数のポートで Port Fast の設定を行うと、設定を行った際に表示される、設定を行ったインターフェースの数の表示が正しくない場合があります。 この問題が発生している際の例を以下に示します。 以下の例では、g1/0/5 から g1/0/8 までの 4 つのインターフェースに対して設定を行っておりますが、5 つのポートに対して設定が適用されるという旨のメッセージが表示されています。 Switch(config)#int range gi1/0/5 - 8 Switch(config-if-range)#spanning-tree portfast %Warning: portfast should only be enabled on ports connected to a single host. Connecting hubs, concentrators, switches, bridges, etc... to this interface when portfast is enabled, can cause temporary bridging loops. Use with CAUTION %Portfast will be configured in 5 interfaces due to the range command but will only have effect when the interfaces are in a non-trunking mode. この問題は表示上のみの問題で、他の機能に影響を与える事はありません。 この問題は CSCtr76519 として報告されております。 |
解決策 | 改修版ソフトウェア : CSCtr76519 の修正が適用された ソフトウェア の使用 |
備考 本不具合は、Bug Search Tool でも確認できます。