ssdi 发表于 2015-6-24 17:55
还是不明白,我配置了,以下内容,但现在打1000提示占线的声音,
R1#dir
Directory of disk0:/
1、需要把以下个文件上传到Flash中,注意文件名字一定要是这个
its-CISCO.2.0.2.0.tcl
en_welcome.au
en_reenter_dest.au
en_enter_dest.au
en_disconnect.au
en_dest_unreachable.au
en_dest_busy.au
2、CME配置部分
application
service aa flash:its-CISCO.2.0.2.0.tcl
paramspace english index 0
paramspace english language en
param operator 100 ///总机号码,听到IVR后拨0所转接分机
paramspace english location flash:
param aa-pilot 199 //拨打听到IVR的号码
param welcome-prompt _welcome.au
3、配置Dial-peer用于匹配到IVR
dial-peer voice 199 voip
corlist incoming deny
service aa
destination-pattern 199
session target ipv4:1.1.1.1 //路由器IP地址
incoming called-number 199
dtmf-relay h245-alphanumeric
codec g711ulaw
no vad
4、路由器上手动加载welcome文件,系统会提示加载成功
audio-prompt load en_welcome.au
Cisco TAC不会支持你针对its脚本进行修改.