ASR9000 シリーズルータの Tomahawk LC を起動する場合は、下記全ての条件を満たしている必要があります。
- 全ての Fan Tray が V2 Fan Tray であり正しく挿入されていること
- 全ての Fan Tray が正常に稼動している状態であること (アラーム状態ではないこと)
上記条件を満たしていない場合、Tomahawk LC 起動時に下記メッセージが出力され、IN-RESET 状態になることは期待された動作となっております。
RP/0/RP0/CPU0:May 9 18:00:26.303 : shelfmgr[408]: %PLATFORM-SHELFMGR-3-INCOMPATIBLE_FT_FOR_LC : A9K-NP300-LC with V1 Fantray is NOT a supported configuration due to limited cooling capabilities of V1 Fantray. Chassis has an incompatible Fantray v1 type for LC 0/0/CPU0.
RP/0/RP0/CPU0:May 20 09:47:35.331 : shelfmgr[419]: %PLATFORM-SHELFMGR-3-INCOMPATIBLE_FT_FOR_LC : All the Fantrays must be V2 in order to provide cooling for the A9K-NP300-LC. Chassis has incompatible Fantray for Node 0/0/CPU0.
- show platforms 出力例 (IN-RESET)
RP/0/RP0/CPU0:ASR9K#admin show platform
Mon May 9 18:06:24.778 UTC
Node Type State Config State
-----------------------------------------------------------------------------
0/RP0/CPU0 A99-RP2-TR(Active) IOS XR RUN PWR,NSHUT,MON
0/RP1/CPU0 A99-RP2-TR(Standby) IOS XR RUN PWR,NSHUT,MON
0/FT0/SP ASR-9922-FAN-V2 READY
<0/FT1/SP が非搭載>
0/FT2/SP ASR-9922-FAN-V2 READY
0/FT3/SP ASR-9922-FAN-V2 READY
0/0/CPU0 A9K-8X100GE-TR IN-RESET PWR,NSHUT,MON <<< IN-RESET 状態となる
-- snip --
上記 は "0/FT1/SP" が非搭載のため、0/0/CPU0 が IN-RESET 状態となります。 0/0/CPU0 の Tomahawk LC を起動する場合は、Fan Tray 1(0/FT1/SP) を追加し、全ての Fan Tray が挿入されかつ正常(State: READY)の状態を確認した上で、0/0/CPU0 の Tomahawk LC を再起動して下さい。
また、Tomahawk LC については下記 Data Sheet を参照して下さい。