以下の方法でFPR1000/FPR2100のFXOSのパスワードリカバリーが可能です.
本体を再起動し,起動シーケンス時における「Use BREAK or ESC to interrupt boot.」出力時においてESCを押し,ROMMONモードに移行します.
*******************************************************************************
Cisco System ROMMON, Version 1.0.12, RELEASE SOFTWARE
Copyright (c) 1994-2019 by Cisco Systems, Inc.
Compiled Mon 06/17/2019 16:23:23.36 by builder
*******************************************************************************
Current image running: Boot ROM1
Last reset cause: ResetRequest (0x00001000)
DIMM_1/1 : Present
DIMM_2/1 : Present
Platform FPR-2130 with 32768 MBytes of main memory
BIOS has been successfully locked !!
MAC Address: 00:b7:71:19:d9:80
Use BREAK or ESC to interrupt boot.
Use SPACE to begin boot immediately. ### ここでESCを入力
Boot interrupted. ### Bootが中断されROMMONモードに移行します
rommon 1 > factory-reset ### プロンプトより'factory-reset'と入力します
Warning: All configuration will be permanently lost with this operation
and application will be initialized to default configuration.
This operation cannot be undone after booting the application image.
### 問題無ければ'yes'と入力
Are you sure you would like to continue ? yes/no [no]: yes
### 問題無ければ'ERASE'と入力
Please type 'ERASE' to confirm the operation or any other value to cancel: ERASE
Performing factory reset...
Located '.boot_string' @ cluster 1052363.
Rommon will continue to boot the application: disk0:installables/switch/fxos-k8-fp2k-lfbff.2.9.1.131.SPA
Are you sure you would like to continue ? yes/no [no]: yes
Located 'installables/switch/fxos-k8-fp2k-lfbff.2.9.1.131.SPA' @ cluster 957908.
#########################################################################################################
[以下略]
起動完了後,FXOS, ASA共に全ての設定が初期化された状態となりますので,そこでパスワードの再設定を含め,FXOS, ASAの再設定を実施します.
一部の古いドキュメントにおいてROMMONモードから'password_reset'と入力してパスワードの初期化を行うドキュメントがございますが,このコマンドはROMMON Version 1.0.04までのものには実装されておりますが,ROMMON Version 1.0.06以降のリリースには削除されておりご利用いただけません.
参考資料