2013-06-18 05:06 PM
the problem WLC 5508 can't detect LAP 1040 either in the same vlan or other . i attached the scenario with the discussion .
2013-06-19 09:57 AM
Hi,
Thanks for visiting Support Comunity Japan. Your question would have a better change to catch users' attension in the wireless community provided by Support Community English, https://supportforums.cisco.com/community/netpro/wireless-mobility.
Since this is Small Business Wireless LAN community, please move your quesion to the desired community and wait for replies!
Thanks so much.
Cisco Support Community Japan
2013-06-19 09:59 AM
Post the following output:
1. WLC: sh sysinfo;
2. WLC: sh time;
3. AP: sh version; and
4. AP: sh inventory
2013-06-20 07:31 PM
. WLC: sh sysinfo;
(Cisco Controller) >show sysinfo
Manufacturer's Name.............................. Cisco Systems Inc.
Product Name..................................... Cisco Controller
Product Version.................................. 6.0.199.4
Bootloader Version............................... 1.0.1
Field Recovery Image Version..................... 6.0.182.0
Firmware Version................................. FPGA 1.3, Env 1.6, USB cons
1.27
Build Type....................................... DATA + WPS
System Name...................................... Cisco_62:54:24
System Location..................................
System Contact...................................
System ObjectID.................................. 1.3.6.1.4.1.9.1.1069
IP Address....................................... 10.10.30.2
Last Reset....................................... Power on reset
System Up Time................................... 0 days 2 hrs 18 mins 0 secs
System Timezone Location.........................
Current Boot License Level....................... base
Current Boot License Type........................ Permanent
Next Boot License Level.......................... base
Next Boot License Type........................... Permanent
--More-- or (q)uit
Configured Country............................... EG - Egypt
Operating Environment............................ Commercial (0 to 40 C)
Internal Temp Alarm Limits....................... 0 to 65 C
Internal Temperature............................. +38 C
External Temperature............................. +29 C
Fan Status....................................... OK
State of 802.11b Network......................... Enabled
State of 802.11a Network......................... Enabled
Number of WLANs.................................. 1
3rd Party Access Point Support................... Disabled
Number of Active Clients......................... 0
Burned-in MAC Address............................ 00:06:F6:62:54:20
Power Supply 1................................... Present, OK
Power Supply 2................................... Absent
Maximum number of APs supported.................. 25
2. WLC: sh time;
(Cisco Controller) >show time
Time............................................. Thu Jun 20 12:07:02 2013
Timezone delta................................... 0:0
Timezone location................................
NTP Servers
NTP Polling Interval......................... 86400
Index NTP Server
------- --------------------------------
about
3. AP: sh version; and
4. AP: sh inventory
when i connect console to LAP there is no any output from console , i think because it make restart every time
エキスパートの回答、ステップバイステップガイド、最新のトピックなどお気に入りのアイデアを見つけたら、あとで参照できるように保存しましょう。
コミュニティは初めてですか?これらのヒントを活用してスタートしましょう。 コミュニティの活用方法 新メンバーガイド
下記より関連するコンテンツにアクセスできます