取消
显示结果 
搜索替代 
您的意思是: 
cancel
3570
查看次数
0
有帮助
2
回复

小白请教一个2960镜像口报错的问题

jialingwang4038
Spotlight
Spotlight

监控到镜像口一直有丢包,不知是正常吗,有啥办法解决。

 

FastEthernet0/11 is up, line protocol is down (monitoring)
Hardware is Fast Ethernet, address is 5835.d9dc.018b (bia 5835.d9dc.018b)
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
reliability 255/255, txload 3/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 100Mb/s, media type is 10/100BaseTX
input flow-control is off, output flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output 14w1d, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 869217240
Queueing strategy: fifo
Output queue: 0/0 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 1445000 bits/sec, 853 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts (0 multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
0 input packets with dribble condition detected
6375142851 packets output, 1958806912752 bytes, 0 underruns
0 output errors, 0 collisions, 1 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 PAUSE output
0 output buffer failures, 0 output buffers swapped out

 

 

 


monitor session 1 source vlan 1
monitor session 1 destination interface Fa0/11
end

2 个已接受解答

已接受的解答

YilinChen
Spotlight
Spotlight

你的镜像配置是所有VLAN1 的流量,都镜像给FA0/11口,如果流量大于100M,你又是一个百兆口,丢包是正常的;
如果说是流量小于100M,检查一下物理网线吧,然后清下计数器,再观察。

在原帖中查看解决方案

2 条回复2

YilinChen
Spotlight
Spotlight

你的镜像配置是所有VLAN1 的流量,都镜像给FA0/11口,如果流量大于100M,你又是一个百兆口,丢包是正常的;
如果说是流量小于100M,检查一下物理网线吧,然后清下计数器,再观察。

谢谢

入门指南

使用上面的搜索栏输入关键字、短语或问题,搜索问题的答案。

我们希望您在这里的旅程尽可能顺利,因此这里有一些链接可以帮助您快速熟悉思科社区:









快捷链接