取消
显示结果 
搜索替代 
您的意思是: 
cancel
公告

December 2020

December 2020

660
查看次数
0
有帮助
1
回复
default-dd1
Beginner

N7009重置密码,重启后进入系统后,配置文件没有了

重启设备,进入密码重置环境后,加载ios后,却发现提示如下:
2020 Dec 29 15:05:36 switch %$ VDC-1 %$ %PLATFORM-2-MOD_PWRUP: Module 7 powered up (Serial number JAE19170EEU)
2020 Dec 29 15:05:40 switch %$ VDC-1 %$ %PLATFORM-2-FANMOD_FAN_OK: Fan module 1 (Fan1(sys_fan1) fan) ok
Abort Auto Provisioning and continue with normal setup ?(yes/no):
Starting Auto Provisioning...Done
Abort Auto Provisioning and continue with normal setup ?(yes/no): #正常情况下不会提示这个出厂配置提示,而是直接提示输入用户/密码
整个操作过程如下:
loader> dir
bootflash:
lost+found
n7000-s2-kickstart.6.2.2a.bin
n7000-s2-dk9.6.2.2a.bin
vdc_2
scripts
20150606_114612_poap_7181_init.log
20150811_032244_poap_6925_init.log
loader> boot kickstart bootflash:/n7000-s2-kickstart.6****bin sup-1
switch(boot)# conf t
Enter configuration commands, one per line. End with CNTL/Z.
switch(boot)(config)# admin-password Cisco@******
WARNING! Enabling local authentication for login through console due to password recovery
switch(boot)(config)# exit
switch(boot)# load n7000-s2-dk9.6.****.bin
System image digital signature verification successful.
2020 Dec 29 15:05:35 switch %$ VDC-1 %$ %PLATFORM-2-MOD_PWRUP: Module 3 powered up (Serial number JAE191908QH)
2020 Dec 29 15:05:35 switch %$ VDC-1 %$ %PLATFORM-2-MOD_DETECT: Module 7 detected (Serial number JAE19170EEU) Module-Type 1/10 Gbps BASE-T Ethernet Module Model N7K-F248XT-25E
2020 Dec 29 15:05:36 switch %$ VDC-1 %$ %PLATFORM-2-MOD_PWRUP: Module 7 powered up (Serial number JAE19170EEU)
2020 Dec 29 15:05:40 switch %$ VDC-1 %$ %PLATFORM-2-FANMOD_FAN_OK: Fan module 1 (Fan1(sys_fan1) fan) ok
Abort Auto Provisioning and continue with normal setup ?(yes/no):
Starting Auto Provisioning...Done
Abort Auto Provisioning and continue with normal setup ?(yes/no):
输入yes或者no后,进入提示输入用户名和密码,验证用户后,show run 发现配置没了
1 条回复1
JimJim1
Beginner

我恢复过N9K-93180YC的密码,恢复流程跟你基本一致,唯一的不同是在进入leader模式后,我先输入cmdline recoverymode=1 后再重新load nxos ,重启完修改密码,配置未丢失
不能显示该小部件。