取消
显示结果 
搜索替代 
您的意思是: 
cancel
609
查看次数
0
有帮助
2
回复

9115 作为EWC控制器,下面有接了1815w ap,怎么启用1815w下的以太网口

YiHuang63964
Level 1
Level 1

你好!该怎么配置,有文档介绍吗?最好的是中文的,另外怎么优化5G的连接速度,外网是1000m,无线测速下只有300-500m,谢谢!

2 条回复2

1.看需求应该是需要配置Remote LAN

有关远程 LAN 的信息
远程 LAN (RLAN) 用于使用控制器对有线客户端进行身份验证。 一旦有线客户端成功加入控制器,LAN 端口就会在中央或本地交换模式之间切换流量。 来自有线客户端的流量被视为无线客户端流量。

接入点 (AP) 中的 RLAN 发送身份验证请求以对有线客户端进行身份验证。 RLAN 中有线客户端的认证类似于中央认证的无线客户端。

RLAN is supported in APs that have more than one Ethernet port.


The supported AP models are:

  • Cisco Catalyst 9105AXW

  • Cisco Catalyst 9105AXIT

  • Cisco Aironet OEAP 1810 series

  • Cisco Aironet 1815T series

  • Cisco Aironet 1810W series

  • Cisco Aironet 1815W

可以看看如下文档:

https://www.cisco.com/c/zh_cn/support/docs/wireless/catalyst-9800-series-wireless-controllers/215681-configure-oeap-and-rlan-on-catalyst-9800.html#anc11

 

2.关于速率协商的问题,首先可以确认一下AP的理论速率

AP9115来说;

802.11n version 2.0 (and related) capabilities

●  4x4 MIMO with four spatial streams
●  Maximal Ratio Combining (MRC)
●  802.11n and 802.11a/g beamforming
●  20- and 40-MHz channels
●  PHY data rates up to 890 Mbps (40 MHz with 5 GHz and 20 MHz with 2.4 GHz)
●  Packet aggregation: A-MPDU (transmit and receive), A-MSDU (transmit and receive)
●  802.11 Dynamic Frequency Selection (DFS)
●  Cyclic Shift Diversity (CSD) support

802.11ac

●  4x4 downlink MU-MIMO with four spatial streams
●  MRC
●  802.11ac beamforming
●  20-, 40-, 80-, and 160-MHz channels
●  PHY data rates up to 3.47 Gbps (160 MHz with 5 GHz)
●  Packet aggregation: A-MPDU (transmit and receive), A-MSDU (transmit and receive)
●  802.11 DFS
●  CSD support

802.11ax

●  4x4 downlink MU-MIMO with four spatial streams
●  Uplink/downlink OFDMA
●  TWT
●  BSS coloring
●  MRC
●  802.11ax beamforming
●  20-, 40-, 80-, and 160-MHz channels
●  PHY data rates up to 5.38 Gbps (160 MHz with 5 GHz and 20 MHz with 2.4 GHz)
●  Packet aggregation: A-MPDU (transmit and receive), A-MSDU (transmit and receive)
●  802.11 DFS
●  CSD support

对于AP1815w

802.11ac

●  2x2 single-user/multiuser MIMO with two spatial streams
●  Maximal Ratio Combining (MRC)
●  20-, 40-, and 80-MHz channels
●  PHY data rates up to 866.7 Mbps (80 MHz on 5 GHz)
●  Packet aggregation: A-MPDU (Tx/Rx), A-MSDU (Rx)
●  802.11 Dynamic Frequency Selection (DFS)
●  Cyclic Shift Diversity (CSD) support

如果AP的速率协商的不够高,可以看看channel bandwidth是否可以调整一下。

Device(config)#ap dot11 5ghz rrm channel dca chan-width {20 | 40 | 80 | best | 160 | best maximum {20 | 40 | 80 | MAX}}

信道频宽约宽,协商的速率可能就越高,但是注意干扰等负面因素带来的问题可能性也会更大。

https://www.cisco.com/c/en/us/td/docs/wireless/controller/9800/config-guide/b_wl_16_10_cg/radio-resource-management.html

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Rps-Cheers | If it solves your problem, please mark as answer. Thanks !

好的。谢谢!我来试试看,有问题再请教你,谢谢!

入门指南

使用上面的搜索栏输入关键字、短语或问题,搜索问题的答案。

我们希望您在这里的旅程尽可能顺利,因此这里有一些链接可以帮助您快速熟悉思科社区:









快捷链接