Customer Environment = Company Office
Controller = Catalyst 9800
Access Point = 9115AXI
Clients[Average]= 6~10 per AP
AP Installation Interval: 8~10 meters
PHY type: 802.11n/ac/ax(5G), 802.11g/n/ax(2.4G)
Does anyone give me some suggestions about the best setting values for the RRM [Radio Resource Management] in RF profile?
<1>General [Current Values]
Profile Thresholds for Traps
->Interference(%)* = 10(2.4G/5G)
->Clients* = 12(2.4G/5G)
->Noise(dBm)* = -70(2.4G/5G)
->Utilization(%)* = 80(2.4G/5G)
<2>Coverage [Current Values]
Coverage Hole Detection
->Minimum Client Level (clients)* = 3(2.4G/5G)
->Data RSSI Threshold (dBm)* = -80(2.4G/5G)
->Voice RSSI Threshold (dBm)* = -80(2.4G/5G)
->Exception Level(%)* = 25(2.4G/5G)
<3>TPC [Current Values]
Transmit Power Control
->Maximum Power Level(dBm)* = 30(2.4G/5G)
->Minimum Power Level(dBm)* = -10(2.4G/5G)
->Power Threshold V1(dBm)* = -70(2.4G/5G)
<4>DCA [Current Values]
Dynamic Channel Assignment
->Avoid AP Foreign AP Interference = enable (2.4G/5G)
->Channel Width = best (2.4G/5G)
->DCA Channels = Except for 165,184,188,192,196 (5G)
->DCA Channels = Except for 12,3,4,6,7,8,10,11,12,14 (2.4G)
Hign Speed Roam
Mode Enable = disable (2.4G/5G)
Neighbor Timeout* = 5 (2.4G/5G)
Client Network Preference = Connectivity (2.4G/5G)
Band Select (Only for 2.4G)
->Probe Response = disable
Client RSSI (dBm)* = -80
Client Mid-RSSI (dBm)* = -80
Cycle Count (cycles)* = 2
Cycle Threshold (msec)* = 200
Expire Dual Band (sec)* = 60
Expire Suppression (sec)* = 20
