取消
显示结果 
搜索替代 
您的意思是: 
cancel
公告

December 2020

December 2020

转一篇ME固件升级文章

811
查看次数
0
有帮助
3
评论
After login into your Aironet Access Point console, enable it
#show version //to check your current version. eg AP Running Image : 8.2.111.0
#capwap ap ip 10.0.0.101 255.255.255.0 10.0.0.1 //Set an IP address to your CAPWAP AP
#show ip int br // to make sure your IP address is set
# ping 10.0.0.2 //Make sure your TFTP Server is reachable.
# ap-type mobility-express tftp://10.0.0.2/AIR-AP3800-K9-ME-8-5-103-0.tar //ME File we download
If you found any error, you might need to upgrade your CAPWAP version to the latest first. One of the possibility is your current version less than 8.3 and you will need to upgrade to CAPWAP 8.3 or higher:
#ap-type mobility-express tftp://10.0.0.2/ap3g3-k9w8-tar.153-3.JF.tar //Upgrade from CAPWAP 8.2 to 8.5
#show version // now to check your current version after an upgrade. The version should be at AP Running Image : 8.5.103.0
How to convert Cisco CAPWAP to Mobility Express# ap-type mobility-express tftp://10.0.0.2/AIR-AP3800-K9-ME-8-5-103-0.tar //run again this command to upgrade to ME
Note that with current Cisco Aironet 1800 Series, 2800 Series, 3800 Series, as long the SKU end with K9, it will be CAPWAP version (Lightweight AP or Controller Based AP), it need a controller, not able to standalone. To become a standalone access point, you need to convert CAPWAP to Mobility Express.
If you looking for standalone AP, or Mobility Express Version, do request SKU end with K9C, eg Air-AP1832I-K-K9C, it will come with mobility express firmware.
评论
sufee
Beginner
学习一下!1!
mis0000016
Beginner
总结的不错,简单实用!
mis0000016
Beginner

很实用,收下了。

不能显示该小部件。