CISCO2921/K9 路由器双wan怎么指定某vlan通过特定的wan口上网

[yxbnet]

route-map user626 permit 11
match ip address 11
set ip next-hop 126.86.178.118

access-list 11 permit 192.168.11.0 0.0.0.255

ip policy route-map user626（应用在wan口上）

这样配置以后192.168.11.0网段为什么不通过指定的wan口上网，哪里配置有问题？

[Rps-Cheers]

建议将ip policy route-map user626配置放在LAN口一侧。例如如下的E0/0口

[ilay]

使用PBR调整流量时需要将PBR应用到设备的入向接口，PBR优先级高于本地的路由表。你将route-map 应用到WAN接口，流量已经按照地址查完路由表决定路由走向了，直接转发出去，根本不会匹配你配置的route-map        //关于PBR可以看下英文的定义（Policy-based routing (PBR) is a process whereby the device puts packets through a route map before routing them. The route map determines which packets are routed to which device next. You might enable policy-based routing if you want certain packets to be routed some way other than the obvious shortest path）

另外，需要注意将源地址NAT成相应wan接口的有效公网IP地址