The results of the current command execution are as follows:
# show platform hardware fed active fwd resource tcam utilization
Codes: EM - Exact_Match, I - Input, O - Output, IO - Input & Output, NA - Not Applicable CAM Utilization for ASIC [0]
Table Subtype Dir Max Used %Used V4 V6 MPLS Other
------------------------------------------------------------------------------------------------------
...
IP Route Table TCAM I 65536 65536 100.00% 65527 6 2 1
...
If TCAM extension is possible Or if there is another way, please let me know.
Please note that SDM Prefer is available only in Access.