cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

103
Views
0
Helpful
1
Replies
Beginner

AMP4E macOS - AMP Connector status is never "Connected"

Does the macOS Connector only operate in an Offline mode? 

Device Trajectory has very minimal to almost no information compared to a Windows Connector. 

Also, scans executed by the AMP Console don't seem to actually occur and local scans never appear in the AMP Console.

 

In the AMP Console, the device hasn't appeared to communicate since the initial install.

 

Screen Shot 2019-11-08 at 11.59.30 AM.png

Everyone's tags (3)
1 REPLY 1
VIP Advisor

Re: AMP4E macOS - AMP Connector status is never "Connected"

Hi

Does your Mac has the firewall service enabled or any 3rd party tool line little snitch...?
Can you check on your event monitor or on your amp deamon log which is normally located in /Library/Logs/Cisco/

Thanks
Francesco
PS: Please don't forget to rate and select as validated answer if this answered your question