If you have any features/improvement suggestions, let us know below.
Forum Posts
Cluster bring up failed at install stage: 'Execute cluster validation tests', please check and retryVerify network connectivity between all nodes.Timed out, last status: [Node-2-Lead]: pending[Node-3]: pending[Node-1]: pendingVerify firewall to allow...
Hello team,I installed ND 4.1.1g with the ova on esxi 8.x. I follow the deployment guide with the pre-requirements, basically : - 16Vcpu-64G of ram-SSD disk (50 + 500G)-Add vlan 4095 on the data interface in the parameters of vswitch-Deactivate time ...
the data interfaces on the nexus dashboard, should that network be in overlay network or underlay network?
With regards to virtual dashboard Nexus app mode, please advise on the minimum hardware platform requirements for hosting the ND-VIRTUAL in application mode. My customer currently has only 8 CPUs available, while the datasheet specifies a minimum of ...
I've been using Nexus Dashboard 4.1(1g) to configure a route peering service to a firewall cluster. The configuration seems to be deployed ok, however I notice that when I detach the Service Insertion from the Border switches, Nexus Dashboard decide...
I'm configuring an Enanched Classic Lan Fabric with Nexus Dashboard 4.1.1I'm looking for the API payload to attach a vlan/network to an interface of an Access switch The Example in the reference guide is [{"networkName": "MyNetwork_30000","lanAttachL...
If you have any features/improvement suggestions, let us know below.
I have nexsusdashboard cluster 3 nodes ver 3.2.1 on esxi after i upgrade to 3.2.2m the ndfc can not load the app and i get error on the cluster that the logs are 100% and i see that /logs/k8_infra/ and confd are 100% so it doesnt go up how i delete t...
Team, I am trying to configure an interface via Manage > Fabric > connectivity > interface -- Edit configuration.. Configuring all required parameters including the Access VLAN... and deploying it.. All successful.. Now when i go to Manage > Segm...
I'm wondering if with the ND 4.1.1 and enabling the telemetry, is still necessary to configure the EPL (endpoint locator) framework, or just the communication in OOB using the management network of ND cluster and the mgmt interfaces of leaves and spi...
I am setting up a singe node lab setup. I have specified Manangemt IP (192.168..0.x/24) IP and a data subnet ip (10.10.10.10/24) during installation. I have specified persistent IPs 10.10.10.11-13 and NDFC moved to "cluster bring up" page where it ca...
Is it possible to specify a different multicast group address per each bridge domain with ND 4.1.1? I would like to avoid to use the same 239.1.1.0/25 for all the BDs (L2VNIs) in order to optimize the BUM traffic spreading across the VXLAN fabric. ...
Hi, Does Cisco Nexus Dashboard Insights support SNMP? I checked the datasheet link https://www.cisco.com/c/en/us/products/collateral/data-center-analytics/nexus-insights/datasheet-c78-742685.html but didn't find SNMP shown but I find it difficult th...
Hi guys , i am testing NDFC multisite configuration over simulator EVE_ng .. deployed NDFC as a VM , and leaf and spine nodes topology under EVE-ng . For the VM external connectivity , i created a network cloud and attached all nodes mgmt interface t...
Hi All,Local users works fine, but we need to use external authentication, our option is only RADIUS or LDAP (=> Windows AD). RADIUS users can loging to our ND but get only read-only access !? same users/accounts from the same source can login to the...
