I have tried that and am getting different results than I expected. My expected behavior is that I call the auth endpoint (with async) - that sends the push out. Afterwards I can call the auth_status periodically and will get “waiting” returned until such time as the user either approves or denies. Given the code below, I am still getting a timeout. See code and results below:
code
$authConnection = getAuthConnection();
$factorParams = array("device"=>"auto","type"=>"UMBC TSC",null,"pushinfo"=>"from=UMBC%20Technology%20Support%20Center&Purpose=Identity%20Validation");
print "*** Sending Push: " . date('Y-m-d H:i:s') . "\n";
$PushResult = sendAsyncPush($authConnection);
print_r($PushResult);
$txid = $PushResult["response"]["response"]["txid"];
print "*** Calling auth_status 1 of 2 " . date('Y-m-d H:i:s') . "\n";
$PushResult = $authConnection->auth_status($txid);
print_r($PushResult);
print "*** Calling auth_status 2 of 2 " . date('Y-m-d H:i:s') . "\n";
$PushResult = $authConnection->auth_status($txid);
print_r($PushResult);
print "*** done " . date('Y-m-d H:i:s') . "\n";
Executing this gives the following results:
*** Sending Push: 2018-10-26 11:00:59
Array
(
[response] => Array
(
[response] => Array
(
[txid] => 12345-12345-12345-12345-12345
)
[stat] => OK
)
[success] => 1
[http_status_code] => 200
)
*** Calling auth_status 1 of 2 2018-10-26 11:01:00
Array
(
[response] => Array
(
[response] => Array
(
[result] => waiting
[status] => pushed
[status_msg] => Pushed a login request to your device...
)
[stat] => OK
)
[success] => 1
[http_status_code] => 200
)
*** Calling auth_status 2 of 2 2018-10-26 11:01:00
Array
(
[response] => Array
(
[stat] => FAIL
[code] => 28
[message] => Operation timed out after 10001 milliseconds with 0 out of -1 bytes received
)
[success] =>
[http_status_code] =>
)
*** done 2018-10-26 11:01:10```
