Version: 2.1(1h)
Hi,
Our apic3 was previously connected to our Leaf 101 and 102.
Yesterday, this Apic3 was moved to a new building and connected to leaf 103/104.
Apic3 is not anymore connected to the leaf 101/102.
Apic3 has been correctly discovered and added to the fabric as a fully fit controller :-)
Unfortunately, the topological map was not correctly refreshed and the former connections to leaf 101/102 are still present... and also the new ones towards the leaf 103/104 (See below).
Maybe a cosmetic issue ? How could I solve this problem.
Below the lldp information :
apic3# fabric 101 show lldp neighbors
----------------------------------------------------------------
Node 101 (leaf101)
----------------------------------------------------------------
Device ID Local Intf Hold-time Capability Port ID
apic2 Eth1/47 120 eth2-1
apic1 Eth1/48 120 eth2-1
spine201 Eth1/49 120 BR Eth1/1
...
apic3# fabric 103 show lldp neighbors
----------------------------------------------------------------
Node 103 (leaf103)
----------------------------------------------------------------
Device ID Local Intf Hold-time Capability Port ID
apic3 Eth1/48 120 eth2-2
spine201 Eth1/49 120 BR Eth1/3
...
apic3# fabric 104 show lldp neighbors
----------------------------------------------------------------
Node 104 (leaf104)
----------------------------------------------------------------
Device ID Local Intf Hold-time Capability Port ID
apic3 Eth1/48 120 eth2-1
spine202 Eth1/50 120 BR Eth1/4
...
Accepted Solutions
