ACISim - Issue to retrieve spine and leaf

[Cedric42]

ello,

I installed ACISim 6.1(2g) with ESX 7.0 and during the fabric steup, only one leaf is shown. Intial setup was set for a one POD including 2 spine ans 2 leaves.

Is someone has any idea about this issue ?

[AshSe · Accepted solution]

Hi @Cedric42 

---

@Cedric42 wrote:

ello,

I installed ACISim 6.1(2g) with ESX 7.0 and during the fabric steup, only one leaf is shown. Intial setup was set for a one POD including 2 spine ans 2 leaves.

Is someone has any idea about this issue ?

---

This is absolutely fine. Please register the first discovered leaf, then you will get to discover two spine switches. Register them followed by the second leaf.

Feel free if you need in-depth understanding of this process.

Hope This Helps!!!

AshSe

Community Etiquette: 

1. Insert photos/images inline - don't attach.
2. Always mark helpful and correct answers, it helps others find what they need.
3. For a prompt reply, kindly tag @name. An email will be automatically sent to the member.

[AshSe]

Hi @Cedric42 

Additionally you can go through below lab for hands on and step by step details:

Getting Started with Cisco ACI 5.2 v1

[TransatAT]

Hi @AshSe,

Thanks for your reply and help.

I asked to my Cisco representative to get access to the hands on lab.

In the meantime, I registered the first leaf, it became in inactive state and no more leaf or spine appear.

Have a good day,

Cedric

[TransatAT]

Hi @AshSe ,

I found my error : previously I changed the TEP pool scope, now I kept the original one and it works !

Have a nice day,

Cedric

[Wassim Aouadi]

If it is not cumbersome to you, have you rebooted the simulator VM and tried the setup again?

[Cedric42]

Hi Wassim,

Thanks for your help

It was not since it allowed me to set up again and take car to unchange the TEP adresses pool.