Hi,I want to know what steps can be followed for change implementations in Cisco ACI1) to capture the pre and post change logsI am following - configuration snapshot, screenshot of the System health and APIC health, screenshot of the Tenent faults2) ...
Forum Posts
Hi,As per "Cisco APIC Layer 3 Networking Configuration Guide"For IPv6 ND, ACI bridge domain ND always operates in flood mode; unicast mode is not supported.Does it mean that for IPv6 ND traffic the BD will operate in flood mode regardless of the sett...
Apic 4.2 (1j) see screenshots. The fail then pickup again, any ideas, is this a bug?
All I have a program that automates the configuration import from a local configuration backup file into the APIC. However, I have no idea how to check if the import is truly completed so that the next sequential task can be started. Obviously, the ...
Resolved! ACI Simulator retain config
hello, i´m using ACI simulatior 4.2.4. is there any possibilty to retain the config after reboot? it is boring ot go Always tr
Hi, i have 3 tenants and going to have more, at the moment have only 1 vCenter but a plan is to have a vCenter to manage each tenant. There are few reasons, some apps are not supported by newer vCenter, would like to have a lab where i could test new...
Hi All, PFA the diagram. TWO SPINE SWITCHESLEAF 105 & 106 – BORDER LEAF SWITCHES ARE CONNECTED TO SPINELEGACY N7K CORE SWITCH1 IS CONNECTED TO LEAF 105LEGACY N7K CORE SWITCH2 IS CONNECTED TO LEAF 106L3 OUT CREATED BETWEEN N7K AND BORDER LEAF SWITCHES...
can we associate physical domain and VMM domain for a single EPG? is it recommended?
Resolved! Remove domain from AAEP
Good morning,I have a single AAEP for my fabric that contains my physical and VMM domains. I had an old VMM integration that has since been deleted but see that the old domain still exists within my AAEP. It is throwing a fault that the object cann...
Resolved! ACI MultiPod Interconnection IPN usage
Hi all, in a normal MultiPod configuration as picture MultiPoD.png, I'd like understand better how the connections between IPN Pod1 and IPN Pod2 works in terms of traffic flow and bandwidth usage. Assuming to have a 2x10 Gbps dark fiber between I...
Resolved! Nexus 93180YC-FX leaf booting not up
Hi all My company has 2 leaf Nexus 93180YC- FX. After about 2 months of use for ACI architecture. At point time. one leaf Nexus 93180YC-FX inactive. we have checked and seen that. " Nexus 93180YC-FX booting not up" "we using aci mode" Plase help me.T...
I was reading Multisite ACI white paper and as per it intra-VRF is as follows Intra-VRF communication: "In this case, the source EPG and destination EPG belong to different bridge domains mapped to the same VRF instance (the same tenant). The tenant ...
Can we mix Cisco VM-based with CASE-Based ACI MSO? For e.g Two VM-based MSO and one CASE-BAsed? And what are the advantage of using Case-based MSO over VM-based MSO?
Hi, Planning to re-purpose 2 of the ACI leafs (N9K-C93180-FX) y migrating them to nx-os mode and use as core switch pair. I suppose I don't need specific licensing to move from ACI mode to NX-OS mode? Also, once switched to NX-OS mode what license w...
I ran into an issue where the 3 APIC's were using old passwords but I have not those credentials.I want to upgrade the APIC version from 2.2.2j to 4.4.4i, how do I do the upgrade APICs? Note: I Upgraded the APIC CIMC using the Cisco Host Upgrade Util...
