Join the ACI conversation. Jump into this space for access to peers and industry experts. You’ll find the latest updates, helpful resources, and assistance when you need it.
I have read various documents recommending that flooding be enabled to mimic legacy network behavior but i was looking for specific guidance for what scenarios traffic will not reliably work if flooding is disabled under the BD. My intent was to ide...
Hello, is it possible to establish a PORT CHANNEL between a couple of Cisco 6500 running VSS mode and a couple of NEXUS 5000 running vPC? . Design should be " Back-to-Back" : VSS-- Port-Channel--vPC.I want also to support L2 and L3 flows between the...
I create a EPG for vmotion, which doesn't need any contracts.I see the port group in vcenter.Q. how can I configure IP addresses for this vmotion port group ? doing this from vcenter creates error messages, and seems not to be possible.
Hi,Looking at the stats below from the ACE. Can anybody confirm if the hits are only successful negotiations? or are the hits a mixture of rejected/denied and successful negotiations?Cheers LAB/Production# sh stats crypto server cipher+-------------...
Hi, My question is to use policy based service insertion/service graphs between the EPGs communications to redirect traffic to ASA firewall & F5 slb. Below are Cisco ACI components:1- Spines & Leafs2- APIC Controllers3- Cisco ASA Firewall attached t...
For those looking for a deep peek into ACI technical operations, we have began a Webinar series targeting new & existing ACI customers. Webinars will be hosted on a weekly basis on topics suggested by folks like yourselves and usually run about 1 ho...
If I create a complete tenant configuration: tenant, virtual network, bd,......Is there a way to findout the sequence of REST API Calls that would create this configuration; could be used to define scripts ?In UCS there is a nice feature, that allows...
I have a scenario where there is Cisco Switch at one side and Juniper Switch at another side. Juniper Switch is equipped with FE SFP and Cisco Switch with GbE SFP. Is communication possible between two switches?
Hi!I'd like to ask if it's possible to create a default route to an external L3 network that can be shared by multiple tenants?I've tried various methods such as creating the External Routed Network under the Common tenant, but I was unable to see ho...
Hi!I have a static route that I'm not able to remove from a leaf switch.Previously, I've added a bridge domain with a 10.88.88.0/24 subnet; this resulted in the following route being created:10.88.88.0/24, ubest/mbest: 1/0, attached, direct, pervasiv...
In the Nexus 3K OpenStack Plugin for Neutron data sheet (link below) references layer 2 function like Vlan programming and layer 3 function adding SVIs. Is there any document which clearly specifies which functions are support. For eg: Configuring H...
Hi After building a new fabric I have noticed the following interfaces are built on each leaf, can you confirm what the purpose of these interfaces?vlan9, Interface status: protocol-up/link-up/admin-up, iod: 118, IP address: 10.0.0.30, IP subnet: 1...
Hi Experts When you assign a EPG to a Leaf port and is not making any Fabric access-policy do that port, what will the port/fabric Do, is thera any default Policy that is working/running in that case ?Which 1 Gig SFP is supported on the Leaf 9396 we...
Hi,I am considering to plan for the stretch fabric design over full meshed or separate fabrics in the three data centers located within 300 meters of range from each other and possibly huge fibers are available to interconnect them.All three data cen...
