Hi all, Is there any way that we see the leaf endpoint tables from GUI? Also, is there anyway that we can see mac adress tables of a leaf from GUI? Everything is done from GUI but the visibility from GUI is a little weak in my opinion. Regards.
Hello Community,I'm trying to configure private VLAN / Intra EPG isolation in my ACI/VMM environment, but I'm little unsure if i have configured everything correct.My steps:1. EPG/VLAN (for the VMs which should be isolated) - Activated Intra EPG Isol...
Hello everyone, I have got a question about ACI. We are setting up new virtual machines that will work as a HA cluster (vNIOS HA pair). And It has been said to us that the port profile which the LAN ports and vNIOS HA will connect should allow more t...
Hi folks,This is driving me a little crazy! And maybe this is easier than I'm thinking through. I need to add a static route for a network we have that is on ACI ( a BD l3 unicasting routing enabled.) We used to have a static route on IOS but now I'm...
Good afternoon, We are configuring L3OUT using shared secondary IP address with dynamic routing (BGP) to Palo Alto Firewall. We have doubts about if is necessary configure VPC mandatory and if dymanic routing are supported. Testing with single ports ...
Hi Experts , We have multipod setup , below trace is from node in MGT vrf to node in TEC vrf , but as you see at the beginning it gives 2 hops info for the same source gateway IP ... Does anyone knows if this is normal in ACI ? or any logic behind t...
Good Day,I need to configure QoS in my fabric, can anyone please with easy document that can be helpful in configuration please?Many thanks & Regards,
Has anyone used Ansible's flag --diff with any ACI module? I have not observed any difference in the printouts when either using or not using the specific flag. thanks a lot
Hello - we are looking to upgrade to current recommended release, currently on the 4.2.x version. We have thought this might be good time to get up to the most current release with 5.2.x. Does anyone have any insight on issues encountered upgrading...
Hi, TBH, I think I'm actually documenting a bug, but I hope someone cam either tell me I'm wrong and why, oractually do something about fixing the bug Here's my picture I have two PCs on the same subnet, one being attached via a VPC to a L2 switch -...
I found out the configuration on our ACI has 2 area 0 that reside in a different tenant.One area 0, which the old one config is used in L3out from ACI to ASR-1001x. (Gateway reside to Internal firewall)And the other one is used in ACI to Fortigate, w...
Good Day, Anyone can please help to understand how ACI load balancing is done in virtual port-channel? Also if there is vPC between leaf and Firewall, how firewall understands the load balance method from switches (leaf) side? Many Thanks & Regards,
Like screenshot shows, how can I clear out those L2 endpoints manually?The only way I found so far is to go to the associated BD to toggle the "L2 Unknown Unicast" option but doing that would clear all the learned endpoints...So how about if I just n...
hello,is there anyway from the GUI to find physical interfaces that belong to a specific description?something equal to: #show interface description | i dc or a command on the leaf? Best regardsEzzedine
Hello Guys, I have a ACI setup of 1 spine, 2 leaf and APIC controller (c220 M3) for testing. However i am not able to take the console access or gui access of the controller. Lead and spine are accessible through normal process via console. Initial...
.jpg "VIP Advisor"){kind=icon}
